When uploading large files it is necessary to use our SI-CLI tool. The program must be started via the command line.


Tutorial:




The following steps are necessary:


  1. To upload the data will be necessary to separate the taken photos in 2 different sets : AI (the photos  for the AI process) and Mod (the set of photos took for the process of "Images to 3D Model")
  2. Before to upload the data is important to have in mind the corresponding ID of the project that was created during the creation of the inspection.  
  3. Put the unzipped "si-cli.exe" in any folder on your computer. Make sure the file name is exactly "si-cli.exe"
  4. Write in the address bar, where the "si-cli.exe" is located the word "cmd"
  5. It will appear a command line interface
  6. To upload the AI data set, write the next command line "si-cli.exe upi -t ai"
  7. Afterwards you will need to type  the e-mail linked to the account, your password,the Inspection ID and the url where the photos are located on your computer
  8. Afterwards you will see the status of the upload process and you will know is done,when the process reached 100%
  9. To upload the Mod data set, write the next command line "si-cli.exe upi -t mod"
  10. Afterwards you will need to type  the e-mail linked to the account, your password, the Inspection ID and the url where the photos are located on your computer 
  11. Afterwards you will see the status of the upload process and you will know is done,when the process reached 100%